VT Software to Upgrade CUBOID Pro - Joyetech Electronic Cigarette

ARE YOU OF LEGAL SMOKING AGE?

YES (21+)

NO (UNDER 21)

THE PRODUCTS ON THIS WEBSITE ARE INTENDED FOR ADULTS ONLY.

By entering this website, you certify that you are of legal smoking age in the state in which you reside

WARNING: This product contains nicotine.Nicotine is an addictive chemical. Our products are restricted to adults 21+ only.
All the products shown on Joyetech global official website are not allowed to promote or sell in the U.S. Market.

Product
Compliance
Manufacturer
Community
Support

This VT software is for upgrading your CUBOID Pro to the latest Firmware Version. Your temperature control device will be always up to date because of upgradeable firmware.

Change log for V1.13
Bug fix and system optimization. Suggest updating to achieve the best vaping experience.

Previous updates
Set the wallpaper and screensaver
The CUBOID Pro supports wallpaper display. Upload the photos (in jpg format with 240(W)*320(H) max pixel and saved as numbers from 01 to 100) with VT software.
It also supports screensaver where you can set clock (digital/analog) or photos as you prefer. The photos will scroll to display. You can also set certain photo as the screensaver. Slide to choose the photo, re-click the wallpaper icon which will turns to red instantly. Then it'll display that photo only in standby.

Set timeout protection
For safety reasons, if you hold the fire button over a certain period, the device will shout down automatically. Press the fire button 5 times to turn it on again.
Under 'Vapor hub' menu in system setting, turn on the timeout function and set the duration from 5s to 15s. Click cloud icon to go back the main menu. We kindly suggest you turn on this function.

Preheat Function
The Cuboid Pro comes with the preheat function, allowing to start firing at a high output for a few seconds to warm up. This is especially an essential when using an RDA, RTA, ceramic heads and so on.

Under 'Vapor hub' menu in system setting, turn on the 'Preheat' function and set the duration. The device will run at this wattage for the time you set everytime you hold the fire button (under power mode). There'll also a small 'P' on the info bar after you activate it.

Nicotine intake
Under 'Vapor hub' menu in system setting, turn on the 'Nicotine' calculator function. Set the level and monitor duration, it'll calculate your nicotine intake automatically. And interestingly, you'll find the puff/pedometer icon is replaced by an emoji.

Turn on/off the TAP button
Under 'Vapor hub' menu in system setting, you're able to turn the TAP button on or off. When it is off, you are unable to vape by holding the TAP button.

Reverse charge
The Cuboid Pro can be served as a power bank to charge other e-cigarettes or electronic devices.

1. Download the latest VT Software for Cuboid Pro and upgrade your device up-to-date.
2. Install the avatar reverse charging (RC) adapter on the 510 connector.
3. Under system menu, click 'USB Charge' and turn it on.
4. Back to the home interface, click the cloud icon on the upper right to switch the modes. Choose the USB charge mode, connect it with your electronic devices via the USB cable to charge. If it is not in use, please turn on the function.