detail - Joyetech Electronic Cigarette

ARE YOU OF LEGAL SMOKING AGE?

YES (21+)

NO (UNDER 21)

THE PRODUCTS ON THIS WEBSITE ARE INTENDED FOR ADULTS ONLY.

By entering this website, you certify that you are of legal smoking age in the state in which you reside

WARNING: This product contains nicotine.Nicotine is an addictive chemical. Our products are restricted to adults 21+ only.
All the products shown on Joyetech global official website are not allowed to promote or sell in the U.S. Market.

Product
Compliance
Manufacturer
Community
Support

Cuboid

Cuboid, applies Variable Temperature Control system with firmware V3.0 and 150W output, having Temp-SS316 and customized TCR available now.
It is powered by two replaceable 18650 cells with the new slip-open cover.
Multiple colors, 0.96-inch OLED screen and the new dual-battery bar display make it more practical and attractive catering to your preference.
Upgradeable firmware enables it always up-to-date. Now you can upgrade your Cuboid to 200W via VT Software.

Standard Configuration:
1 * Cuboid (no cell)
1 * USB Cable
1 * Manual
1 * Warranty Card

Product Parameters:

150W Output and Dual Battery Bar

Cuboid uses two replaceable batteries with the new dual battery bar.
The maximum output can be reached to 150W, making it powerful and convenient.
We kindly recommend high-rate 18650 cells with continuous discharge current≥25A.

New Slip-open Cover and Battery Reverse Polarity Protection

The new slip-open cover on the bottom enables you change your battery swiftly by pulling the slider over.
With the Onboard Reverse Polarity Protection, it will protect the device from damage in the event of reverse battery installation.

Please pay attention to the positive and negative terminal signs when installing new batteries.

Firmware Upgradeable

Cuboid comes with the upgradeable firmware.
Having Version 3.00 for Cuboid, Temp-SS316 and TCR are available now.

Newly added SMART Mode in Version 3.01 and 3.11

Firmware for Cuboid

Temp-SS316 Mode Based on the previous Temp-SS mode, we developed the new Temp-SS316 mode.
We kindly recommend you using Joyetech BF-SS316 atomizer heads (0.5ohm/1.0ohm).

Customized TCR Available
Cuboid enables you to adjust TCR values for different materials,
thus further improving the accuracy of temperature control and bringing you the great taste.
There are three options (M1, M2, M3) for you to customize the TCR regarding to the material.

In power-off condition, press the fire button and the right regulator simultaneously for around 5 seconds, then you enter into the TCR set menu:
And here's the TCR Value Range for your reference:

Exquisite 510 Stainless Steel Thread
Applied with 510 stainless steel thread and wide border fitting for large capacity atomizers.

Charging & Upgrading

We kindly suggest you take out the cells and charge them with a separate charger.
The micro USB port is on the top of the left side. Connect it with a micro USB cable to charge or upgrade your device.